Re: TV karta - pv 951 - nenajde to zadny program

[Tomáš Dvořák <tom bod dvorak zavinac elektrahk bod cz>]

Muj vypis dmesg:
tvaudio: TV audio decoder + audio/video mux driver
tvaudio: known chips: 
tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6320,tea6420,tda8425,pic16c54 
(PV951),ta8874z
Linux video capture interface: v1.00
kobject_register failed for i2c_algo_bit (-17)
 [<c0209339>] kobject_register+0x49/0x80
 [<c0138705>] mod_sysfs_setup+0x55/0xb0
 [<c01398bf>] load_module+0x87f/0xb30
 [<c0139c1b>] sys_init_module+0x7b/0x1a0
 [<c01033b5>] syscall_call+0x7/0xb
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI Interrupt 0000:00:0b.0[A] -> Link [LNKD] -> GSI 12 (level, 
low) -> IRQ 12
bttv0: Bt878 (rev 17) at 0000:00:0b.0, irq: 12, latency: 32, mmio: 
0xde001000
bttv0: using:  *** UNKNOWN/GENERIC ***  [card=0,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
tvaudio: found pic16c54 (PV951) @ 0x96
tveeprom(bttv internal): Huh, no eeprom present (err=-121)?
bttv0: using tuner=-1
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... not found
bttv0: registered device video0
bttv0: registered device vbi0


takze si myslim, ze to v pohode nahral, ale co mi vrta hlavou je, ze 
kdyz spoustim kdetv, tak mi to hazi tento "error":
kdetv: CfgData: Saving settings for device: BT878 video ( *** 
UNKNOWN/GENER Video4Linux(/dev/video0)
kdetv: CfgData: Saving picture settings for device: BT878 video ( *** 
UNKNOWN/GENER Video4Linux(/dev/video0) with key: television

jestli to teda je error
a dalsi co nechapu je, ze mi pri spustenym kdetv nebezi VBI decoder, je 
tam cervena tecka :( jinak vsechno by melo bejt ok
Petr Pokluda napsal(a):
> Tomáš Dvořák píše v So 10. 09. 2005 v 07:46 +0200:
>
> > Zdravim, mam tv krartu pv 951 s chipem bt848 na linuxu debian 3.1r0a s 
> > jadrem 2.6.12.5. Problem je v tom, ze kdyz spustim program Kdetv, tak mi 
> > to nenajde zadny program. Lsmod vypisuje tyto hodnoty:
>
> Dovolim si poslat odkaz na http://www.abclinuxu.cz/hardware/show/9059
> popripade http://www.abclinuxu.cz/hardware/show/1896
> Nejedna se nahodou o kartu s bt878?
> Co vypisuje dmesg?
>
> ******** muj vypis pro orientaci **********
> Linux video capture interface: v1.00
> bttv: driver version 0.9.15 loaded
> bttv: using 4 buffers with 2080k (520 pages) each for capture
> bttv: Bt8xx card found (0).
> bttv0: Bt878 (rev 17) at 0000:02:05.0, irq: 21, latency: 32, mmio:
> 0xf4000000
> bttv0: using: Askey CPH05X/06X (bt878) [many vendors] [card=24,insmod
> option]
> bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
> bttv0: using tuner=1
> bttv0: i2c: checking for MSP34xx @ 0x80... not found
> bttv0: i2c: checking for TDA9875 @ 0xb0... not found
> bttv0: i2c: checking for TDA7432 @ 0x8a... not found
> tvaudio: TV audio decoder + audio/video mux driver
> tvaudio: known chips:
> tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6320,tea6420,tda8425,pic16c54
>  (PV951),ta8874z
> bttv0: i2c: checking for TDA9887 @ 0x86... not found
> tuner: chip found at addr 0xc0 i2c-bus bt878 #0 [sw]
> tuner: type set to 1 (Philips PAL_I (FI1246 and compatibles)) by bt878
> #0 [sw]
> bttv0: registered device video0
> bttv0: registered device vbi0
> bttv0: registered device radio0
> bttv0: PLL: 28636363 => 35468950 .. ok
> bttv0: add subdevice "remote0"
>
> ************* konec vypisu *******************
>
> v /etc/modules je
> tvaudio
> bt878
> bttv
>
> a v /etc/modules.conf mam
> alias char-major-81 videodev
> alias char-major-81-0 bttv
> options bttv pll=1 card=0 tuner=1 radio=1
> post-install bttv /sbin/modprobe "-k" "tvaudio"
> post-install tvaudio /sbin/modprobe "-k" "snd-intel8x0"