Re: Podivné připojování USB disku Jogr

[Ivan Ferdo <markiza zavinac gmail bod com>]

Vyzera to na zle naformatovany usb kluc.  Asi okienkami.

Vytvorit nanovo fdiskom.

On 12/16/05, Vit Kotačka <vit bod kotacka zavinac gmail bod com> wrote:
>
> Dobrý den
>
> Při připojení USB flash disku (JOGR, A-DATA, 256 MB) se mi v Gnome
> připojí 2 disky: výměnný svazek 249,8 MB a výměnný
> svazek 250 MB. V tom prvním je normální obsah disku a patří k /dev/sda1,
> ve druhém je sposta (512) nesmyslných souborů (o velikosti 282,8 MB) a
> patří k /dev/sda.
>
> Dělá mi to na notebooku i na desktopu. Pokud připojím jiný USB disk,
> funguje všechno v pořádku.
>
> Ještě doplňující informace:
>
> guido zavinac kotacka2:~$ dmesg
> ...
> usb 4-5: new high speed USB device using ehci_hcd and address 14
> hub 4-5:1.0: USB hub found
> hub 4-5:1.0: 1 port detected
> usb 4-5.1: new high speed USB device using ehci_hcd and address 15
> scsi6 : SCSI emulation for USB Mass Storage devices
> usb-storage: device found at 15
> usb-storage: waiting for device to settle before scanning
> Vendor: USB 2.0   Model: Flash Disk        Rev: PROL
> Type:   Direct-Access                      ANSI SCSI revision: 00
> SCSI device sda: 512000 512-byte hdwr sectors (262 MB)
> sda: Write Protect is off
> sda: Mode Sense: 00 06 00 00
> sda: assuming drive cache: write through
> SCSI device sda: 512000 512-byte hdwr sectors (262 MB)
> sda: Write Protect is off
> sda: Mode Sense: 00 06 00 00
> sda: assuming drive cache: write through
> /dev/scsi/host6/bus0/target0/lun0: p1
> Attached scsi removable disk sda at scsi6, channel 0, id 0, lun 0
> usb-storage: device scan complete
> FAT: utf8 is not a recommended IO charset for FAT filesystems,
> filesystem will be case sensitive!
> FAT: utf8 is not a recommended IO charset for FAT filesystems,
> filesystem will be case sensitive!
>
> guido zavinac kotacka2:~$ tail /var/log/messages
> ...
> usb 4-5: new high speed USB device using ehci_hcd and address 16
> hub 4-5:1.0: USB hub found
> hub 4-5:1.0: 1 port detected
> usb 4-5.1: new high speed USB device using ehci_hcd and address 17
> scsi7 : SCSI emulation for USB Mass Storage devices
> usbcore: already loaded
> usb-storage: already loaded
> Vendor: USB 2.0   Model: Flash Disk        Rev: PROL
> Type:   Direct-Access                      ANSI SCSI revision: 00
> SCSI device sda: 512000 512-byte hdwr sectors (262 MB)
> sda: Write Protect is off
> SCSI device sda: 512000 512-byte hdwr sectors (262 MB)
> sda: Write Protect is off
> /dev/scsi/host7/bus0/target0/lun0: p1
> Attached scsi removable disk sda at scsi7, channel 0, id 0, lun 0
> sd_mod: loaded sucessfully (for disk)
> atkbd.c: Unknown key pressed (translated set 2, code 0xaa on
> isa0060/serio0). atkbd.c: Use 'setkeycodes e02a <keycode>' to make it
> known.
> atkbd.c: Unknown key released (translated set 2, code 0xaa on
> isa0060/serio0). atkbd.c: Use 'setkeycodes e02a <keycode>' to make it
> known.
> usb 4-5: USB disconnect, address 16
> usb 4-5.1: USB disconnect, address 17
>
> Guido
> ________________________________________________
> CZdebian-l maillist  -  CZdebian-l zavinac debian bod cz
> http://www.debian.cz/mailman/listinfo/czdebian-l
> E-mail (un)subscriptions: czdebian-l-request zavinac debian bod cz
>